Stepper Motor Controller Project:


Main Title: Hardware Interface
Project: Robot Arms Controller Stepper Motor.
Developer: Md. Redwanur Rahman
Location: Dhaka, Bangladesh.
Date: 24 September, 2007

I am here to share knowledge with other
Aim of this project
Using Computer you can control a stepper motor. This concept can be used for robot walking or arms movement, door opening, Machineries control etc.

Needed components
Uni-polar Stepper Motor, 1K Resistor, Transistor (TIP110), Diode (1N4001), D25 connector with wire (printer port connector), +12v Power supply.

Circuit details
Connect D25 connector pin 2 to the circuit Pin 2 and D25 connector pin 3 to the circuit Pin 3 so on. Circuit Ground, must connect to D25 connector pin 18 ~25. Transistor is used to switch Stepper motor coils. Use Uni- polar stepper motor that has 5 wires. One wire is common source and other connected to ground. Transistor is using to select which coil should be grounded. Diodes are use for guide corresponding transistor. Need to fiddle with coil’s wire to get the exact order. Incorrect order will cause the motor to either step irregularly, or not at all. Depend on Motor and transistor supply voltage may change. (see Uni-polar Stepper Motor circuit)

Program Details

Public Port, X, Y As Integer
Private Declare Function Inp Lib "inpout32.dll" Alias "Inp32" (ByVal PortAddress As Integer) As Integer Private Declare Sub Out Lib "inpout32.dll" Alias "Out32" (ByVal PortAddress As Integer, ByVal Value As Integer)
Public Sub Command1_Click()
Timer1.Enabled = True
Timer2.Enabled = False
End Sub

Private Sub Command2_Click()
Timer1.Enabled = False
Timer2.Enabled = True
End Sub

Private Sub Command3_Click()
Timer1.Enabled = False
Timer2.Enabled = False
End Sub

Private Sub Command4_Click()
Out Port, 0
End
End Sub

Private Sub Form_Load()
Port = &H378 ' LPT1 Port Address
Out Port, 0
X = 0
Y = 0
Text1.Text = Y
End Sub

Private Sub Timer1_Timer()
If Y = 360 Then
Y = 0
End If
Out Port, X + 1 'Send signal to Pin 2 (D25 Connector)
Out Port, X + 2 'Send signal to Pin 3 (D25 Connector)
Out Port, X + 4 'Send signal to Pin 4 (D25 Connector)
Out Port, X + 8 'Send signal to Pin 5 (D25 Connector)
Y = Y + 1
Text1.Text = Y
End Sub

Private Sub Timer2_Timer()
If Y = 0 Then
Y = Y
Y = 360
End If
Out Port, X + 8 'Send signal to Pin 5 (D25 Connector)
Out Port, X + 4 'Send signal to Pin 4 (D25 Connector)
Out Port, X + 2 'Send signal to Pin 3 (D25 Connector)
Out Port, X + 1 'Send signal to Pin 2 (D25 Connector)
Y = Y - 1
Text1.Text = Y
End Sub
Operation
In controller window has some buttons like “Left Move”, “Right Move”, “Stop” and “End”. Press buttons to control the uni-polar stepper motor.

Conclusion
I developed this circuit and program code that published by C NEWS in Bangladesh, 2007.

Download this program

Visitor Number